Installing the CP 3100
Installing an Internal CP 3100
25
Installing the Internal CP 3100
To install the CP 3100 in your computer:
1.
Shut down the computer as you would normally. Then turn off all peripherals connected to it.
2.
Disconnect the computer’s AC power cord.
3.
Remove the computer cover to gain access to the inside of the computer. The documentation
that came with your computer should explain this procedure.
4.
Select an available 5.25-inch, half-height mounting bay and remove the front panel
5.
Install the CP 3100 in the mounting bay by sliding the unit through the front of the computer
(see Figure 4 on page 25).
Figure 4.
Installing the CP 3100
NOTE. If you disconnect cables to gain access to the mounting bay, note which cables were
removed. You can then refer to this information when you reconnect the cables at the end of this
procedure.
