CertainTeed TrueComfort, Руководство оператора

Страница: 22 / 32

22
T
roubleshooting
TrueComfort System
Troubleshooting
continued
PRObLEM LIkELY CAUSE REMEDY
Air comes out from the end of
the hose, but no insulation. A jam has occured within the
agitation system and caused the
agitator and airlock to stop rotating.
Disconnect power cord at the
machine. Remove hopper. Locate the
compacted clump of insulation and
loosen or remove. Reattach hopper.
Agitation system stopped
rotating. Tripped agitator circuit breaker. A
jam has occured within the agitation
system and caused the agitator and
airlock to stop rotating.
Disconnect power cord at the
machine. Remove hopper. Locate the
compacted clump of insulation and
loosen or remove. Reattach hopper.
Reset agitator circuit breaker on
electrical panel.
Chain has come off due to the
following: master link has loosened
and fallen off or the half link cotter
pin has loosened and fallen off.
Disconnect power cord at the
machine. Remove filter panel and all
internal electrical connections going
to the panel. Check for missing chain
on bottom of pan. Reinstall chain and
adjust chain tensioner. Reattach all
electrical connections, filter panel and
secure with fasteners.
Key for the agitator motor, agitator
shaft or airlock shaft has come
loose or is missing.
Disconnect power cord at the
machine. Remove filter panel and all
internal electrical connections going
to the panel. Check for missing 3/16"
key on the following: agitator motor,
agitator shaft, airlock shaft. Note: On
early models, there may be two 3/16"
keys used on the airlock shaft.
When the agitation system
starts or is running, ratcheting
noise occurs within the base of
machine. Chain is “jumping” or skipping
teeth on the sprockets. Tensioner
has loosened and is not supplying
sufficient tension to the chain and
sprockets.
Disconnect power cord at the
machine. Remove filter panel and all
internal electrical connections going
to the panel. agitator motor, agitator
shaft and airlock shaft. Note: On early
models, there may be two 3/16” keys
used on the airlock shaft.