CertainTeed TrueComfort, Руководство оператора

Страница: 21 / 32

21
PRObLEM LIkELY CAUSE REMEDY
Plugging of hose. Worn seals in airlock. Replace seals in airlock section of
base. Minimum psi = 2.0.
Hose is too long. The machine is supplied with 100’ of
hose. If additional hose length was
added, remove hose added beyond
100'.
Hose connections may
be leaking. Check the connection between the
2.5" hose outlet and quick hose
connect. Minimum psi = 2.0. It may be
necessary to replace one or all of the
components to correct air leakage.
Blower brushes worn,
causing lower pressure. Remove blower, check blower motor
brushes for minimum length. Brush
length should not be less than 1/4".
Replace blower motor.
Air comes out from the end of the
hose, but no insulation. Bridging of insulation inside hopper. The agitation system has carved (dug
out) a pocket underneath the insulation,
causing the insulation material to stop
feeding into the airlock.
1) Push or wiggle on the insulation
above the agitators until it begins to
feed the airlock.
2) Disconnect power cord at the
machine. Remove hopper. Locate
and collapse air pocket in insulation.
Reattach hopper.
T
roubleshooting