CertainTeed TrueComfort, Руководство оператора

Страница: 13 / 32

13
At this point you should have the hopper attached, a 50' power cord plugged into the machine and a 115 VAC 15
amp household outlet, and 100' of 2.5" blowing hose attached to the outlet of the machine.
Note: The attic should be prepared before any insulation is added.
Contact your local building code department for further details.
Next, run the 100' of 2.5" hose into the attic and to the furthest point. Next, locate the circuit breaker on the base
of the machine and depress to the “on” position (Fig 11). Once the main circuit breaker has been depressed the
“READY LIGHT” on the operator panel will illuminate indicating the machine is ready for use (Fig 12).
NOTE: If the ready light does not illuminate, check to make sure the hopper is on correctly and the power cord is
supplying power to the machine. When power is present the LED will illuminate.
SET-UP IS COMPLETE AT THIS POINT
OPERATION
Operator Panel
The electrical control of the TrueComfort machine has been designed with the latest technology to allow the
operator full control of the machine at either the ground or in the attic. The operator panel has two push buttons
for the “on”/ “off” function and a ready light to let the operator know when the machine is ready for use (Fig
13). When the green push button is depressed it will first start the blower, then 3-5 seconds later it will start the
agitator. To stop the entire machine (blower and agitator), depress the red button.
NOTE: You cannot run the blower or agitator independently of each other!
Setup and Operation
Note: If the ready light is not illuminated,
the machine will not operate before these conditions
are corrected:
• Hopper is attached correctly.
• Machine circuit breaker turned on.
• Agitator circuit breaker reset.
• Power cord is plugged in.
Fig. 12
Ready Light
Ready Light
Fig. 11
Machine Circuit Breaker
Fig. 13
Ready Light Operator Panel
On (Green) Off (Red)