Centurion BENINCA IT24N, Руководство по установке

Страница: 25 / 48

10. Adjust the open limit switch by loosening the screw and then moving the disc until the open
microswitch is triggered in the desired position.
11. Close the foundation box by adding the cover plate, and securing it to the box via the cover
fixing brackets.
Open endstop
3. It is possible to use the internal limit switch
to stop the gates in the open position.
4. Alternatively mechanical endstops can be
used, mounted where each leaf swings to, in
the open position.
5. The limit switch disc should already have
been mounted onto the motor’s output
shaft at an earlier stage.
6. Assemble the microswitch group in either of
the positions available, depending on the
type of installation.
7. Only one of the two microswitches provided will be used.
8. Determine which microswitch will be activated when the gate opens.
9. Select the common and normally-open terminals of this microswitch to be connected to the
controller:

Black – Common
 Blue – Normally-open: use
 Red – Normally-closed: ignore
page 22
FIGURE 24
FIGURE 25
Cover plate
Fixing
screws
Fixing brackets
Foundation box
Microswitch
group