CENTURION SYSTEMS RDO II, Руководство по установке

Страница: 7 / 24

- 7 -
INSTALLATION MANUAL – RDO
D. Check For Correct Function Of The Door
Before beginning the installation of the RDO II, check that the garage door is functioning correctly. The garage
door must be well-balanced and operate smoothly and freely. When opened to between 900~1200mm from the
floor and released, the garage door should remain in one fixed position and not rise or fall more than 100mm. It
should not bind or stick in the side tracks. The ideal operational effort required to open or close the garage door
should not exceed a force of 15kg. (Refer Item 3, Page 2)
Important Note: The RDO II must not be installed on a poorly-adjusted, worn or damaged door.
E. Weight Bar
The main purpose of the weight bar is to eliminate the possibility of the garage door curtain “ballooning” when
starting from the fully open position. With the weight bar fitted, the garage door should have a natural tendency
to lightly free fall from the mid-open position.
F. Left / Right-Hand Installation
The RDO II has been factory-set to be installed on the right-hand end of your garage door (when viewed from
inside the garage looking out). Flip dipswitch 6 to the ‘ON’ position for a left-hand installation, and to the ‘OFF’
position for a right-hand installation. Please refer to Section 13.4 for further information.
G. Control Box Location
Mount the Control Box on a smooth, flat surface. The area must be completely free from
exposure to water, either direct (rain, garden hose, sprinklers, etc.) or indirect
(seepage either through or down the internal face of the wall). The Control Box contains
sensitive electronics which will sustain damage as a result of any water ingress.
Water-damaged electronics are not covered under the terms of the opener warranty.
Important Note: The control box is not waterproof!
H. Battery Charger
The plug-in battery charger is provided to keep the batteries charged to an optimum voltage. A green coloured
LED, located on the charger casing will illuminate to indicate that the charger has been connected to an active
power supply.
Important Note: Do not mount the charger any further away from the control box than the connection
cable allows. Please ensure that a 220V mains point is provided at the control box for the charger.
I. Battery Cable Connection
In order to conserve battery power prior to installation, the RDO II is
supplied with the positive (red) battery cable disconnected from the
battery terminal.
Connect this cable as follows prior to commencing the installation;
Remove the Control Box lid and connect the red cable to the positive
(+) battery terminal as depicted in Figure 6 (Item 7).
Once connected, the lid can be refitted.
Fig. 6