CENTURION SYSTEMS RDO II, Руководство по установке

Страница: 22 / 24

- 22 -
INSTALLATION MANUAL – RDO
13.14. Holiday Lockout mode
• During Holiday Lockout mode all functionality is disabled and the RDO II will only function upon receiving a
signal from a pre-learned remote control
• Holiday Lockout Mode will not function unless at least one remote control has been previously learned with this
function
13.15. Technical specifications
Configuration Separate Control Box & Drive Unit
Input voltage 220V AC +/-10% 50Hz
Charger 27.5V, 200mA peak current.
Controller voltage 24V DC
Opener lifting force 300N
Opener opening/closing limits travel 4.5 Turns of Door Drum Wheel
Receiver type NOVA code rolling
Receiver code storage capacity 22 Transmitter Codes
Transmitter frequency 433 MHz
Transmitter battery voltage 12 Volt
Globe 15W 24 V DC Edison screw Type
Safety reverse system Pot Adjustable Current Sensing
Table 5
TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE CAUSES REMEDY
Door will not operate
Mains power not turned on
Door is obstructed
Turn on mains power
Remove obstruction
Door is locked or motor
jammed
Mechanical door lock has been engaged
Unlock door
Inspect door and remove jam
Door will not reverse on
hitting an object
Safety Obstruction Force setting is too high
and may require adjustment.
Refer to Installation instructions
Door moves
downwards and
reverses itself upwards
Safety Obstruction Force setting is too low
and may require adjustment.
Adverse weather conditions (wind or cold)
causing door to stiffen and become tight.
Possible obstruction under door
Refer to Installation Instructions
Door operates from
drive unit but not from
hand transmitter
Transmitter is damaged or broken
Transmitter Code has not been programmed
into the receiver
Receiver antenna wire not straight
Battery flat.
Try to operate the door with an
alternative transmitter. Locate and
stretch aerial wire to be as straight
as possible
Replace battery(12V)
Door does not close
fully
Limit micro switch incorrectly adjusted Re-adjust limit switch
Lights malfunction Globe blown Replace with 24V DC/3W globe
Door Stops on upward
cycle before reaching
the fully open position
Door may be obstructed.
Door springs may have lost tension
Safety Obstruction Force may need
adjustment
Disengage Opener and check
door for free movement
Call serviceman to affect repairs
Refer Section 8~10 of Installation
manual.
Autoclose not working
P.E. Beam faulty or wiring broken
P.E. Beam obstructed
Autoclose time not set
Repair P.E. or broken wire
Remove obstruction from the path
of beam. Refer to installation inst.
- Items 2 & 5.
Table 6