Operation
Technical instructions REGULATION
PelTec / PelTec-lambda
49
E31
Boiler status:
Boiler work normally. The problem occurs in
the work of additional equipment - "pellet suction system" if installed.
Possible causes:
Check if the flap is blocked with pellets , if the
sensor is soiled with dust, if the sensor is about 1 mm distant
from the flap, if the sensor reacts on the flap ( the LED lamp is
switching on the sensor ).
E32
Boiler status:
Boiler work normally. The problem occurs in
the work of additional equipment - "pellet suction system" if installed.
Possible causes:
Check the pellet level in the big tank/room
, check if the flexible tubes are blocked, check if the turbine
net is full with dust.
Errors of additional equipment: Pelet suction system
E33
Boiler status:
Boiler work normally. The problem occurs in
the work of additional equipment - "pellet suction system" if installed.
Possible causes:
Check the electric connections on the
mole/feeder screw, check the filthiness of the mole/feeder screw
E34
Boiler status:
Boiler work normally. The problem occurs in
the work of additional equipment - "pellet suction system" if installed.
Possible causes:
Check the UTP cable and its connections with
the electric boards.
Errors of additional equipment: CM-GSM
E35
Communication
errorwith CM-GSM
INFORMATION / WARNING
W-state information boiler that does not stop the operation of the boiler
WARNINGS
W1
Boiler status:
Boiler will be work for a while, if pellet tank don’t
be refilled with pellets will be shown „E22 Fuel level” what’s
mean that is no enough fuel for continue of boiler work.
Possible causes
:
Low fuel level in pellet tank, enough for
short time.
Fuel level
W6
Boiler status:
Boiler will be work normally (cause is
neccessary eliminate because, in longer work of boiler, will be
condensation appear in boiler and flue gas tubes clogging).
Possible causes
:
Problem with 4-way mixing valve / motor
device, problem with return flow temperature sensor.
Low return temperature
Boiler status:
Boiler work normally.
The flap is not closed
There are no pellets in the
big tank/room
The Mole or Feeder
screw does not work
Communication error with
the CMVAC
W2
No flame inignition stage
W2_1
Retry ignition
W5
Factory setting loaded
Errors of additional equipment: INTERNET SUPERVISION (WiFi)
E36
Communication error with
WiFi
Boiler status:
The problem occurs in the work of additional
equipment internet supervision (WiFi) if installed.
Possible causes:
Check the UTP cable and its connections
with the electric boards.
Boiler status:
Fire didn't appear after the adjusted max. time.
Boiler will repeat ignition the adjusted number of times before
error E18 appear.
Possible causes:
Poor pellets in the burner for a proper
burning, moist pellets or bad electric heater.
Boiler status:
The boiler works normally with loaded factory
default settings
Boiler status:
The boiler adds a certain amount of pellets and
starts the ignition again adjusted number of times and then
error E18 appear.
Possible causes:
Poor pellets in the burner for a proper
burning, moist pellets or bad electric heater.
