- 7 -
3-1. General Operation for Programming Mode
Programming Mode 1 and Programming Mode 2
SW833 Controller has two programming modes.
Programming Mode 1 allows you to configure B1~B8 and the settings of each input.
Programming Mode 2 allows you to configure the Traffic Arrow function, input configuration
of Traffic Arrow, Standby Mode, B4 flashing mode under Standby Mode and Buzzer ON/OFF
configuration.
You can also reset to factory default configuration in Programming Mode 2.
Enter a Programming Mode
Press B1 and B3 for more than 1 second to enter Programming Mode 1.
Press B2 and B4 for more than 1 second to enter Programming Mode 2.
NOTE:
The indicator light in the upper right corner will flash in single flash for Mode 1, or
double flash for Mode 2.
Change Setting Value
1. Press B1 and B3 for more than 1 second to enter Programming Mode 1.
2. Press the button you would like to configure. The indicator light at the upper left corner will
be lit up to indicate the current setting (1 light = Setting #1, 2 lights = Setting #2… and so
on).
3. Press the button again to go to the next setting. The indicator light will show the current
setting according the rule mentioned above.
4. Press B1 and B3 for more than 1 second to exit and save your configuration.
Chapter 3: Programming & Operation
Mode 1:
Single flash
Mode 2:
Double flash
B1
B2
B3
B4
B5
B6
B7
B8
B1
B2
B3
B4
B5
B6
B7
B8
