- 21 -
Buzzer Setting
Under Programming Mode 2, you can change the buzzer configuration by B3 Setting.
Enter Programming Mode 2 and configure Buzzer Setting as the following table:
Enter Programming Mode 2 and configure Traffic Arrow Function & Input 2 Setting as the
following table:
#
Indicator Light
Description
Set Buzzer to ON.
2
Set Buzzer to OFF.
Traffic Arrow Function & Input 2 Setting
Under Programming Mode 2, you can change the configuration of Traffic Arrow function and
Input 2 (handbrake) by B5 Setting.
NOTE:
Setting #2~#4 are available only when B5, B6, B7, B8 are set as Group1 or Group2.
#
Indicator Light
Description
B5, B6, B7 and B8 are not affected by Input 2.
4
2
3
1
★
default
1
★
default
Traffic arrow can be used when handbrake is ON
Connect Input 2 to handbrake.
1. If Input 2 is ON,
Group 1 / Group 2 / Group 3 are available for
activation.
2. If Input 2 is OFF,
B5, B6, B7 and B8 will be deactivated compulsively.
Connect Input 2 to handbrake.
1. If Input 2 is ON, B5 (warning/in-out mode) will be
activated automatically.
2. If Input 2 is OFF, B5~B8 will be deactivated compul-
sively.
Connect Input 2 to handbrake.
1. If Input 2 is ON and B1 (main warning light) is
activated, B5 will be activated automatically.
2. If Input 2 is OFF or B1 is deactivated,
B5, B6, B7 and B8 will be deactivated compulsively.
Traffic Arrow Indicator Setting
Under Programming Mode 2, you can change the configuration of Traffic Arrow Indicator by
B6 Setting.
NOTE:
Setting #2~#4 are available only when B5, B6, B7, B8 are set as Group1 or Group2.
