Cedima CF-12.4 E-TR, Руководство по эксплуатации и инструкции по безопасности

Страница: 19 / 42

ENGLISH
• CEDIMA
®
• Technical Documentation • All rights reserved as per DIN 34 • Subject to modifications due to progressive development •
4-1
Installation and operation
4.0.1 To be checked on delivery
Please check first the completeness and intactness of
your CEDIMA
®
joint cutter CF-12.4 E-TR. You will find
the scope of delivery in the chapter „Technical data and
accessories“.

The joint cutter can be put into operation without spe-
cial effort or installation. However, when setting up and
operating the machine the following notes as well as
the general safety instructions and the safety instruc-
tions for operating the engine have to be observed.

4.1 Preparing the joint cutter
4.1.1 Adjusting the push handle
– Loosen the star knob screws and pull out the push
handle, according to your body height, allowing you
to move the joint cutter in a comfortable posture
(fig. 4.1).
Fig. 4.1
push handle star knob screws
– Afterwards tighten the push handle by means of the
star knob screws.
4.1.2 Checking the tension of the V-belts
WARNING
Danger of injury! Switch the engine off!
(consider the engine operating manual)!
Secure the joint cutter against unintentional start-
ing and rolling away!
For checking the tension of the V-belts you don’t have
to remove the V-belt protective cover, as there is a
service opening in it (fig. 4.2).
Check the tension of the V-belts as follows:
– Reach through the service opening and press down-
wards the 3 V-belts. The belts must only be pressed
by approx. 10 mm. If you can deflect the belts by
more they require re-tensioning.
For tensioning and replacing the V-belts please refer to
the chapter “Maintenance and care”

.
CF-12.4 E-TR, front Fig. 4.2
motor service opening
4.2 Mounting the diamond saw blade
4.2.1 General notes on mounting
WARNING!
Shut the engine off. Separate the joint cut-
ter of the mains by pulling the plug!
While mounting or dismounting the saw blade
make sure that the joint cutter cannot be started
unintentionally or might roll away.
The drive unit and the cutting shaft’s speed are de-
signed in a way to provide optimal conditions for cutting
with
CEDIMA
®
-dry-cutting diamond blades.
4.0 Installation and operation