23
Removing/fitting the cover
(illustration 25)
Remove the safety harness.
•
Undo all the clasps that fasten the cover onto the seat.
•
To fit the cover place it on the seat, then insert the two strips between the backrest and
•
the seat, fasten them.
Fasten the two clasps found on the seat and the two on the sides.
•
Pass the two strips on the backrest of the cover through the slots in the seat and fasten them.
•
Lastly, fasten the remaining clasps to the backrest, and the two on the headrest.
•
Fitting/removing the mattress pad
(illustration 26)
Undo the safety harness buckle.
•
Place the mattress pad on the seat. Pass the straps through one of the vent positions
•
of the mattress pad.
Fasten the two clasps of the headrest and the two Velcro strips.
•
Fasten all the components of the harness.
•
Fit the protector pads.
•
Basket
The basket is clipped onto the bottom part of the chassis, to take it off simply unfasten
•
the clips and remove it.
The maximum weight that can be carried in the basket is 2.5 kg.
•
It is advisable to empty the basket before folding the pushchair.
•
Maintenance
Periodically grease the mobile parts with a lubricating product (not grease or oil).
•
Check the brakes, harness, clips and mechanisms that can become loose or worn out
•
through use.
Clean the chassis with a damp cloth (never use abrasive products or solvents).
•
Use a sponge with warm water and mild detergent on the plastic parts.
•
Follow the washing instructions for the fabric parts of the pushchair, let them dry fully
•
before folding. Do the same if the pushchair has been exposed to damp conditions to
prevent mould from forming.
Do not use accessories that have not been approved by the manufacturer.
•
The tyre pressure should be 1.5 bar (22 psi; 150 kPa)
•
