650DC DUAL MOTOR CONTROLLER.
NOTE THE TRANSMITTER HAS BEEN PROGRAMMED, it may be necessary to reprogram
by following the specific directions in this manual. DO NOT REMOVE THE TRANSMITTER
BATTERY.
For use with 12 volt dc voltage only
How it Works:
The 650DC Wireless Dual DC Motor Controller that provides RPM control for 2 single, 2 pole,
DC motors that can output up to 200 amps to Motor A (Larger motor or conveyor or auger
motor) and up 100 amps to Motor B (smaller motor or spinner motor) for up to 1 second and a
maximum continuous amperage of 75 to Motor A (larger) and up to 40amps to Motor B
(smaller). The RPM control is done by providing the user 2 separate outputs, approximately 1/3
of the maximum motor RPM for each motor. The 650DC also incorporates a full RPM “Blast”
feature that runs the large motor at moderate speed for 6 to 8 seconds and then automatically
returns to the previous speed and an E-Stop.
To protect the motor and electronics, the 650DC has built-in safety circuits.
Automatic shut down if motor is locked up. How this is done is if the receiver senses a
current draw of more than the rated amps for more than approximately 1000mS the unit
will shut down from 1 to 30 seconds and must be restarted using on off button .
Automatic shut off if the current draws do not drop below the rated amps after 5 to 7
seconds. Once again, the receiver will shut down for 1 to 30 seconds.
Typical Wiring Connection Diagram
MOTOR A
12VDC
Larger Motor
650DC1
RECEIVER
12VDC
GROUND
FROM
REGULATED
SOURCE
PWM OUT
(GREEN WIRE)
HIGH AMP
Conveyor or
Auger Motor
12VDC
GROUND
(BLACK WIRE)
12VDC POWER
FROM
REGULATED
SOURCE (RED
WIRE) should be
6-gauge wire min.
MOTOR B
12VDC
Smaller
Motor
PWM OUT
(YELLOW
WIRE)
LOW AMP
Spinner motor
