Cascade Sciences CVO-2, Руководство по установке и эксплуатации

Страница: 42 / 52

42 | P a g e
cascadesciences.com | Tel. 503 847-9047
OPERATION
Note: The oven temperature probe must be seated in the bottom shelf probe clip to ensure an
accurate temperature display reading. See page 27.
S
ET THE
T
EMPERATURE
S
ETPOINT
Perform the steps below to adjust the set point to your process or application temperature.
Note: if the Temperature display is showing the HLd (Hold), press and hold the Hold
button for approximately 2 seconds to unlock the display. The setpoint cannot be
adjusted while a Hold is active.
End of Procedure
1.
Navigate to the Temperature Set Point Adjustment mode
Briefly push and release either the Up or Down
arrow buttons to activate the temperature setpoint
adjustment mode.
•
The display will briefly flash the letters “SP”, then
show the flashing, adjustable temperature setpoint.
Note : The display will automatically exit the adjustment mode after 5
seconds of inactivity, saving the last shown value as the new setpoint.
Set Temperature
Setpoint Adjustment Mode
Current Setpoint
2.
Set the Temperature Setpoint.
Adjust the setpoint to your process temperature
using the Up and Down arrow buttons.
Set Temperature
New Setpoint
3.
Wait for 5 seconds after entering the Set Point
•
The display will stop flashing, and the setpoint is
now saved in the controller.
•
The oven will now automatically heat or passively
cool to match the setpoint.
•
The display will revert to showing the present
chamber temperature.
Set Temperature
Heating to Setpoint