5
INSTALLATION INSTRUCTIONS
Unpacking:
Before assembling and installing your ceiling fan,
remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging
material, be certain that all parts have been removed.
CEILING HARDWARE
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
FAN PREPARATION
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is
marked ‘
Approved for ceiling fan mounting
’. If it is not, a new
box must be installed.
Prepare for fan installation as follows:
Step A.
Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
MOTOR
COUPLING
TAPERED
THREAD
MOTOR
WIRES
GROUND
WIRE
Step B.
Thread the downrod into the motor coupling until it
stops turning, this will take at least four and a half full turns.
Step C.
Securely tighten the locking bolt to ensure safe op-
eration of your fan.
Tip:
The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the locking
bolt may cause the fan to separate from the
downrod during normal operation!
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN,
INSTALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND
LOCK THE ASSEMBLY
NOTE:
Only one set of blade holders is supplied. Depend-
ing on the fan model and series they will be either the
Commodore Style, the Center Style, the Badge Style with
matching badges, or the Standard Style blade holder.
LOCKING
BOLT
DOWNROD
&
BALL
ASSEMBLY
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
ADDITIONAL HARDWARE
2
1
/
4
†
x 8-32 ROUND HEAD
SCREWS (2)
FLAT WASHER (2)
1
†
x 8-32 ROUND
HEAD SCREWS (2)
LOCKING BOLT
(MOTOR COUPLING)
DOWNROD & BALL
ASSEMBLY
PERMA•LOCK™ HARDWARE
