18
DIP SWITCH
SET TO ‘01001’
DIP SWITCH
SET TO ‘01110’
NOTE:
If this is the second Versa•Touch fan installed in the same
area, one of the fans MUST have its channel changed from ‘01110’ or
interference will occur. Make sure that the dip switch settings in both
the second remote and second fan are set to the same numbers.
VERSA•TOUCH
♦
CONFIRMING CHANNEL DIP SWITCH SETTING - FAN
Checking Fan Setting
Step 1.
Remove the three motor cover screws and lift the motor
cover off. Through the view hole on top of the motor, locate the
dip switch.
Step 2.
Check that the dip switch in the fan and the remote are
set to ‘01110’. If this is a second fan, change the dip switch
settings, making sure that the fan and remote are set to the
same number.
Step 3.
Replace the cover and screws.
VIEW HOLE FOR
DIP SWITCH
R
SEND
SIGNAL
LED
FIVE DIGIT DIP SWITCH
NOTE:
All fans leave the factory set to ‘01110’.
VERSA•TOUCH
♦
CONFIRMING CHANNEL DIP SWITCH SETTING - CONTROL
VERSA•TOUCH OPERATION
Fan Control
To start the fan. Press the selected speed button to run the fan at the desired speed.
LO
Low speed
MED
Medium speed
HI
High speed
To turn off the fan. Press the
FAN OFF
button.
Airflow Direction
To reverse the airflow press the
REVERSE
button. Reverse operates at any speed whether fan is
on or off. The fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the
LIGHT
button. Keep
pressing the button in excess of 0.7 seconds, it becomes a dimmer. The light varies from
‘bright’ to ‘dim’ over approximately 8 seconds. This sequence will reverse the light when it
reaches the brightest or dimmest level if you continue to hold the
LIGHT
button. Release the
button when the desired level is reached.
Auto Resume
Quick (pressing less than 0.7 seconds) on/off operation of the
LIGHT
button maintains the
desired brightness level set previously.
Remote Setting
Step 1.
Remove battery.
Step 2.
Check that the dip
switch in the remote is set
to ‘01110’ - as shown.
Step 3.
Check that the dip
switch in the fan is set the
same. (See section below
for fan dip switch location)
R
