10
Step 1.
Remove the knockout plug in the center of the out-
let box or drill a
1
/
2
†
hole for the lag screw to pass through.
Then drill a
1
/
4
†
guide hole into the joist or beam to a depth
of 3 inches.
Step 2.
Route the outlet box wires through the
1
/
2
†
diameter
outer hole of the outlet adaptor plate.
Step 3.
Line up the slotted holes and four canopy screw
holes in the crossbar mounting bracket and outlet adaptor
plate with the 8-32 mounting holes in the outlet box. Install
the two 8-32 X 2
1
/
4
†
(1
†
) screws and flat washers in fan
hardware kit and tighten securely by
hand
only!
Step 4.
With fender washer and outlet box cable attached as
shown, pass lag screw through center hole of outlet adaptor
plate and screw into pre drilled
1
/
4
†
guide hole of joist. Tighten
until outlet box is firmly mounted.
TIP:
Threading two of the canopy screws into the
crossbar mounting bracket will help everything stay
aligned as you tighten the lag screw. Remove them
before starting Step 5.
WARNING: MOUNT ONLY TO AN OUTLET BOX
MARKED ACCEPTABLE FOR FAN SUPPORT
••••
ADVERTISSEMENT: ASSEMBLER UNIQUEMENT À
UNE BÔITE DE SORTIE JUGÉE ACCEPTABLE POUR
RETENIR UN VENTILATEUR.
FAN INSTALLATION OUTSIDE THE USA - EXCLUDING MODELS ENDING IN ‘E’
OUTSIDE USA - MOUNTING SECONDARY SUPPORT PARTS TO OUTLET BOX
OUTSIDE USA - SECONDARY SUPPORT INSTALLATION PARTS
If you do not have an existing fixture located where you wish to place your Casablanca fan, a new ceiling fixture outlet box
must be installed (use an outlet box marked acceptable for fan support) and an electrical cable to run it.
This box must be
secured to the ceiling according to the outlet box manufacturer’s instructions.
It is recommended that this be done by
a qualified electrician.
Vaulted or Cathedral Ceiling Installations
Your Casablanca fan may be installed on a vaulted or cathedral ceiling in the same manner as described for a flat ceiling. The
Hang-Tru
®
mounting system makes it possible to hang your fan on sloped ceilings up to a 32 angle.
Using Existing Ceiling Fixture Outlet Box
After turning electrical power off, lower the old fixture to expose the wiring and the ceiling fixture outlet box. Cut the
fixture wires or if wire nuts have been used, unscrew them and disconnect the wires. The fixture can then be removed.
After removing the old fixture, check the outlet box to sure that it is supported by a joist or beam across its upper surface.
If not, a 2" x 4" stud must be installed.
3
⁄
8
"- 7 LAG SCREW (5")
FENDER
WASHER
SPRING LOCK
HOOK
6" OUTLET BOX
CABLE
OUTLET
ADAPTOR
PLATE
1
⁄
2
"
HOLE
FENDER
WASHER
1
⁄
4
" GUIDE
HOLE
LAG
SCREW
CROSSBAR
MOUNTING
BRACKET
OUTLET
ADAPTOR
PLATE
JOIST
OR
BEAM
OUTLET
BOX
8-32 X 2
1
⁄
4
"
(1") SCREW
6" OUTLET BOX
CABLE
