Carver Yachts C34 Coupe 2018, Руководство пользователя

Страница: 124 / 184

OWNER’S MANUAL
SYSTEM OPERATING INFORMATION
116
7
3237 • X6 02/2018
Make sure that a sufficient level of coolant mixture is kept
in each system. Open the cooling system seacocks
before starting the engines. The inlet seacocks for each
engine are labeled ENGINE WATER SUPPLY.
Clean the seawater strainer every 14 days or sooner as
necessary.
Serious damage to the engine and related systems can
occur by running an engine with an inadequate supply of
anti-freeze or obstructed seawater pickups or strainers.
NOTICE
The cooling system may need to be repaired if an above-
normal temperature registers on the engine temperature
gauge. If the engine temperature rises quickly,
immediately shut off the affected engine, and have the
cooling system inspected and repaired.
ENGINE ROOM VENTILATION
The engine room is equipped with a ventilation system
that consists of intake ducts, exhaust ducts and bilge
blowers. The ventilation system is designed to remove
fuel vapor and excess heat from the engine room. The
bilge blowers operate when the engines are running, as
long as BILGE BLOWER 1 through BILGE BLOWER 4
and BILGE BLOWER RELAY circuit breakers are ON,
which are located on the DC control center.
The engine room ventilation system must be kept in
proper operating condition. Perform the following actions
to ensure proper condition:
• Inspect the intake and exhaust ducts regularly to
keep free of obstructions. Make sure the ducts have
not collapsed or torn.
• Inspect the blowers to ensure they are operating
properly.
• Replace worn components with new components of
the same type.
Always operate the bilge blower for a minimum
of 4 minutes prior to starting the engines.
Gasoline vapors can explode, resulting in
injury or death. Before starting the engines or
generator, perform the following:
• Check the engine room for fuel vapors.
• Operate bilge blower for 4 minutes – gasoline
engines.
• Verify that blowers are operating properly.
Always run the blower when the vessel is
operating below cruising speed.
WARNING
!
PROPULSION/GENERATOR
MAINTENANCE
Refer to the propulsion and generator Original Equipment
Manufacturer (OEM) information for instructions on
maintaining the yacht’s propulsion units and generator.
A seawater strainer may be installed in the water intake
lines for each engine and the generator. At least once
every 30 days, close the seawater seacocks, and then
open and clean the strainers.
Inspect the strainers more frequently if the yacht is
operated in dirty waters or areas with a high degree of
aquatic vegetation. A clogged strainer restricts the intake
of seawater, which can cause the affected engine or the
generator to overheat.
C34_Coupe.indb 116 2/8/2018 3:43:28 PM