Carrier RTU-MP, Руководство по интеграции

Страница: 5 / 58

RTU-MP Controller 1
The RTU-MP controller was custom designed to be an integrated component of a Carrier rooftop unit. Its
internal application programming provides optimum performance and energy efficiency.
RTU-MP enables the unit to run in a 100% stand-alone control mode (using space temperature and/or
humidity sensors are not required), or it can communicate to the Building Automation System (BAS). On-board
DIP switches allow you choose your protocol and baud rate; BACnet, Modbus, Johnson N2 or LonWorks.
This document will serve as the reference guide for integrating RTU-MP into the BAS. It should be read
thoroughly, understood, and all functions performed by the group installing or commissioning the BAS.
Failure to follow this warning could cause personal injury, death, and/or equipment damage.
ELECTRICAL SHOCK HAZARD
Disconnect all power to the unit before performing maintenance or service. Unit may automatically start if
power is not disconnected.
Introduction