Carrier NDK33BN0KB, Руководство по эксплуатации и обслуживанию

Страница: 66 / 270

62-61753-21 3-18
Table 3-1. Unit Data
* Displays information or setting entered in the microprocessor Configurations
+ May or may not be displayed depending on Parameter/Configuration settings
DATA DEFINITION
SUCTION PRESSURE Compressor suction pressure
DISCHARGE PRESSURE Compressor discharge pressure
EVAPORATOR PRESSURE Leaving evaporator pressure
ENGINE COOLANT TEMP
Engine coolant temperature
RETURN AIR TEMP Return (air entering evaporator) air temperature
SUPPLY AIR TEMP Supply (air leaving evaporator) air temperature
DELTA-T Return air temperature minus supply air temperature
AMBIENT AIR TEMP Ambient (air entering condenser) air temperature
DEFROST TERM TEMP Defrost termination temperature
SUCTION LINE TEMP Suction line temperature at the compressor
EVAP OUTLET TEMP Suction line temperature at the evaporator outlet
COMPRESSOR DIS-
CHARGE TEMP
Compressor discharge temperature
BATTERY Battery voltage
CURRENT DRAW (DC) Battery charging or discharging amps.
ENGINE RPM Engine revolutions per minute
UNIT AC CURRENT #1 High voltage current draw on circuit #1.
UNIT AC CURRENT #2 High voltage current draw on circuit #2.
SUCTION MOD VALVE CSMV % open or "Closing"
EXPANSION VALVE EVXV % open or "Closing"
START MODE AUTO if the engine will start automatically
MANUAL if the engine must be started manually
SOFTWARE REVISION Revision of the software that is operating the microprocessor
DISPLAY SOFTWARE REV Revision of the software that is operating the display
CONTROL SERIAL # Serial Number of the microprocessor
* TRAILER ID # ID (as Configured by the user)
* UNIT SERIAL # Unit serial number
* UNIT MODEL # Unit model number (as Configured by the user)
*
DATALOGGER Displays the current Date and Time that the Data Recorder is using. This may
be different than local time, depending on the Time Zone and Daylight Savings
Time selections made when the Data Recorder was configured.
+ FUEL LEVEL This is only displayed when the sensor is configured ON.
% of fuel in tank.
+ INSTALLED OPTIONS This is only displayed when one or more options is configured ON.
Lists installed options.
+ HOURS TO ENGINE
MAINTENANCE
This is only displayed when the meter is configured ON.
Number of engine hours until the next programmed engine maintenance.
+ HOURS TO S/B MOTOR
MAINTENANCE
This is only displayed when the meter is configured ON.
Number of hours until the next programmed electric standby motor mainte-
nance.
+ HOURS TO UNIT MAINTE-
NANCE
This is only displayed when the meter is configured ON. Number of switch-on
hours until the next programmed general unit maintenance.
+ TIME LEFT TO PM (1-5) This is only displayed when one or more of the meters is configured ON.
Number of hours until the next programmed maintenance. (May display user
programmed identification.)