39
12 - CheCKlIsT TO Be MaDe By The INsTalleR BefORe CallINg CaRRIeR seRVICe COMMIssIONINg
UnIT
Preliminary information
Job name: ..............................................................................................................................................................................................
Location: ................................................................................................................................................................................................
Installing contractor: ............................................................................................................................................................................
Distributor: ...........................................................................................................................................................................................
equipement
Model 30XAV-ZE: ................................................................................................................................................................................
Compressors
Circuit A
Circuit B
Model #
Model #
S/N
S/N
Motor #
Motor #
Inverter compressor frequency
Fan Inverter frequency
Model # (circuit A/B) :
Model # (circuit A/B) :
Serial number (circuit A/B) :
Serial number (circuit A/B) :
evaporator
Model : ...................................................................................................................................................................................................
S/N ..........................................................................................................................................................................................................
Condensing module
Model # : ................................................................................................................................................................................................
Unit options and additional accessories
.................................................................................................................................................................................................................
.................................................................................................................................................................................................................
Is there any shipping damage
..............................................................................................................................................................
If so, where?
...........................................................................................................................................................................................
Will this damage prevent unit start-up?
.............................................................................................................................................
□
Unit is level in its installation
□
Power supply agrees with the unit name plate
□
Electrical circuit wiring has been sized and installed properly
□
Unit ground wire has been connected
□
Electrical circuit protection has been sized and installed properly
□
All terminals are tight
□
All cables and thermistors have been inspected for crossed wires
□
Chilled water pipes are properly connected
□
All plug assemblies are tight
□
The chilled water pump operating with the correct rotation. Check the phase sequence of the electrical connection.
In the case of a unit with hydronic module, use the pump test function (refer to manual control 30XAV-ZE for a
more detailed explanation).
The machine is reset once power off the pump test performed.
□
Circulating ice water in the hydraulic circuit for at least 2 hours, then remove, clean and replace the strainer. The
machine is reset once power off the pump test performed.
□
Piping water inlet to the evaporator includes a strainer with a mesh size of 1.2 mm (20 mesh)
