Carrier AiroVision 39 HQ, Сборка/монтаж, пусконаладка, руководство по обслуживанию

Страница: 19 / 52

19
Fig. 39.
Units with unequal widths - situation B
Fig. 41. Roof finish, situation C, side 4
Fig. 42. Roof installation, unit with longer top cell, Z-
profiles over width profile
Fig. 43. Unit with unequal widths - situation D
Fig. 40. Units with unequal widths - situation C
• Directions 3 and 4: Cut the connection profiles to
the correct length and mount them on the correct
sides.
• Directions 1 and 2: Cut the connection profiles to
the correct length and mount them on the correct
sides (See Fig. 42).
• Directions 3 and 4: Cut the connection profiles to
the correct length and mount them on the correct
sides.
• Direction 1: Cut the connection profiles to the cor -
rect length and mount them on the correct sides
(See Fig. 30).
• Direction 2: Cut the connection profiles to the cor -
rect length and mount them on the correct sides
(See Fig. 38).
• Direction 3: Cut the connection profiles to the cor -
rect length and mount them on the correct sides
(See Fig. 31).
• Direction 4: Cut the connection profile to the cor -
rect length and mount it on the correct side as de-
scribed below.
- Mount Z-profiles over the projecting cross beam of
the top section as described below. Roof membrane
of the bottom casing section can be applied over
these profiles.
• Directions 1 and 2: Cut the connection profiles to
the correct length and mount them on the correct
sides (See Fig. 38).
• Direction 3: Cut the connection profiles to the cor -
rect length and mount them on the correct sides
(See Fig. 31).
• Direction 4: Cut the connection profiles to the cor -
rect length and mount them on the correct sides
(See Fig. 43).