Carrier AiroVision 39 HQ, Сборка/монтаж, пусконаладка, руководство по обслуживанию

Страница: 18 / 52

18
Note: For outdoor installation, seal all ends of the
profiles. Repeat this procedure for all corner and
butt joints.
6.3. Units with Different Widths
For units with different widths, there are 4 different
situations. For an indoor installation the method de-
scribed below applies to all situations.
Indoor Installation
The top cell includes a projecting cross beam that is
effectively as wide as the bottom cell.
• Check that the cover strip at the ends of the bot
-
tom cell is installed in the correct place.
• Position the top section as indicated in drawing.
• Screw the projecting base frame profiles of the top
section to the corner posts of the bottom section.
Fig. 35.
View in width direction, unit with unequal
widths
Fig. 37. Unit with unequal widths - situation A
Fig. 38. Roof finish, situation A, side 2
Fig. 36. View in length direction, unit with unequal
widths
Outdoor Installation
The top cell includes a projecting cross beam that
is effectively as wide as the bottom cell. For outdoor
installation, connection profiles need to be cut to the
proper length. These profiles should be mounted
over the entire unit length and width.
• Position the top section as indicated in the dimen -
sional drawing. The position of the top section can
be as described in one of the four situations be-
low:
• Direction 1: Cut the connection profile to the cor -
rect length and mount it on the correct side (See
Fig. 39).
• Direction 2: Cut the connection profile to the cor -
rect length and mount it on the correct side as de-
scribed below.