14
Timer Operation
• For timer operation, a weekly timer (40RC004603) or a timer on the market is required.
• You can start (ON timer) or stop (OFF timer) the operation of air conditioner at the desired time.
• Setting of the timer operation is available in ALL, ZONE, or UNIT mode.
[Example] A case in which the timer operation is set to ZONE No. 1 (UNIT No. 1 to 5 units are set) is shown below.
FILTER RESET
SET
ON
LOUVER
FAN
TEMP.
MODE
MONITOR/SET ALL/ZONE
ZONE
UNIT
ON CENTER/LOCKED
CHECK
ZONE SET/ENTER SELECT
OFF
TIMER ON
FILTER RESET
1
SET
ZONE
ON
2 3 4 5
LOUVER
FAN
TEMP.
MODE
MONITOR/SET ALL/ZONE
ZONE
UNIT
ON CENTER/LOCKED
CHECK
ZONE SET/ENTER SELECT
OFF
TIMER ON
3
2
3
5
4
FILTER RESET
1
SET
ZONE
TIMER
ON
2 3 4 5
LOUVER
FAN
TEMP.
MODE
MONITOR/SET ALL/ZONE
ZONE
UNIT
ON CENTER/LOCKED
CHECK
ZONE SET/ENTER SELECT
OFF
TIMER ON
6
1
49
64
33
48
17
32
1
ON
MODE
COOL
UNIT
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
FAN
AUTO
TEMP.
˚C
ON
MODE
COOL
FAN
AUTO
TEMP.
˚C
ON
MODE
COOL
FAN
AUTO
TEMP.
˚C
1
Selection of MONITOR/SET
Push “MONITOR/SET” button to match to
“SET”. “MONITOR” indication goes off and
“SET” indication flashes.
2
Selection of ALL/ZONE/UNIT
Push “ALL/ZONE” button to select ALL, ZONE,
or UNIT for the indoor units to be set.
(NOTE) Every pushing the button, indication
changes in the following order.
ALL
ZONE
UNIT
*
When [ALL] is selected, all the UNIT Nos. are
indicated in the Operation monitor indication
screen.
3
Selection of ZONE No./UNIT No.
Push “ZONE” button or “UNIT” button to match
to the ZONE No. or UNIT No. to be set.
4
Selection of Last-push priority/CENTER/
LOCKED
Push CENTER/LOCKED to match indication to
“No indication (Last-push priority)”, “CENTER”
or “LOCKED”.
(NOTE) Every pushing the button, indication
changes in the following order.
No indication
Last-push
priority
CENTER
LOCKED
( )
5
SET
Match MODE, FAN, TEMP., LOUVER, etc.
(For details, see pages 15 to 16.)
6
Timer Link
Push “TIMER ON” button to match indication to
“TIMER”.
(NOTE) Every pushing the button, indication
changes in the following order.
END
Selection of MONITOR/SET
Push “MONITOR/SET” button again to match to “MONITOR”.
“SET” indication goes off, and “MONITOR” indication goes on.
• Indication returns automatically to “MONITOR” after 15 seconds even if END step is not executed, and
setting operation completes.
• ON/OFF buttons are validated even if setting to Timer operation.
• In setting ON/OFF only, operation in steps
4
and
5
is unnecessary.
TIMER
Invalid
(No display)
TIMER
