8200-M554-O1 Rev C 2XX-EIP Installation and Setup Manual
11
205/210 COMMUNICATIONS
Data Sent from the 205/210 Indicator to the PLC
Byte0 Float point weight. Byte 0
Float point weight. Byte 1
Byte1
Byte2 Float point weight. Byte 2
Float point weight. Byte 3
Byte3
Byte4 Weight status. See bit definitions below PWC status. Bit0 = PWC1... 1=on Byte5
Byte6 Cmd0. Returned by the 205/210
indicator when complete
Cmd1. Returned by the 205/210
indicator when complete
Byte7
Data Sent from the PLC to the 205/210 Indicator
Byte0 Cmd0. See definition below
Cmd1. See definition below
Byte1
Byte2 N/A
N/A
Byte3
Byte4 Float point value for Cmd. Byte 0
Float point value for Cmd. Byte 1
Byte5
Byte6 Float point value for Cmd. Byte 2
Float point value for Cmd. Byte 3
Byte7
205/210 WEIGHT STATUS (Data[4])
Bit0 MOTION
Bit1 BELOW ZERO
Bit2 CENTER OF ZERO
Bit3 OVER CAPACITY
Bit4 WEIGH UNITS 0=unit1 (lb)/1=unit2 (kg)
Bit5 WEIGH MODE 0=Gross/1=Net
Bit6 Not defined
Bit7 Scale Error. The indicator has failed to communicate for at least 3 seconds,
data is invalid.
205/210 PWC STATUS (Data[5])
NOTE:
The following status section applies only if the PWC has been enabled. Refer to the
Technical and Installation manual of your indicator for instructions on enabling and using the
PWC feature.
Bit0 PWC1 – 0=off/1=on
Bit1 PWC2 – 0=off/1=on
Bit2 PWC3 – 0=off/1=on
Bit3 PWC4 – 0=off/1=on
Bit4 PWC5 – 0=off/1=on
Bit5 PWC6 – 0=off/1=on
Bit6 PWC7 – 0=off/1=on
Bit7 PWC8 – 0=off/1=on
