Carboline Thermo-Lag 3000, Руководство по применению

Страница: 4 / 42

Table of Contents
Page No.
4.0
PREPARATIONS PRIOR TO THERMO-LAG APPLICATION 6
4.1 DEGREASING, BLASTING AND PRIMING 6
4.1.1 DEGREASING 6
4.1.2 BLASTING 6
4.1.2.2 SURFACE PREPARATION 6
4.1.3 PRIMING 6
4.1.3.1 PRIMER THICKNESS AND ADHESION MEASUREMENTS 6
4.1.3.2 PRIMER REACTIVATING 6
4.1.4 PRIMER ADHESION 7
4.2 SURFACE PREPARATION WHERE AN EXISTING / NON-APPROVED
PRIMER WAS INSTALLED 7
4.3 GALVANIZED SURFACE PREPARATION 7
4.4 STAINLESS STEEL SURFACE PREPARATION 7
4.5 WELD CUT BACK 7
5.0
THERMO-LAG 3000 APPLICATION PROCEDURES 8
5.1 INSTALLATION OF MESH ON STRUCTURAL STEEL I AND H
SECTIONS 9
5.2 FINAL THERMO-LAG 3000 APPLICATION 10
5.2.1 TERMINATION ONTO NON-FIREPROOFED STEEL 10
5.3 FINAL THICKNESS 10
5.4 SAMPLE INSTALLATION 10
5.5 EQUIPMENT CLEANUP / FLUSHING 10
5.6 TOPCOATING 11
5.7 RECORD KEEPING 11
6.0
CLEAN-UP 11
7.0
REMOVAL AND REPAIR PROCEDURES 11
7.1 REMOVAL 11
7.2 REPAIRS - GENERAL 11
8.0
IN SHOP APPLICATION (PRE-ERECTION) 11
8.1 INTRODUCTION 11
8.2 BLOCK OUT AREAS 12
8.3 HANDLING, STORAGE AND ERECTION 12
8.3.1 UNLOADING 12
8.3.2 RIGGING 12
8.4 DUNNAGE 12
8.4.1 ORIENTATION OF MEMBERS 12
8.4.2 STACKING 12
8.5 RIGGING 12
8.5.1 SWING RADIUS 13
8.5.2 CONSIDER GROUND ASSEMBLY 13
8.6 LIFTING 13
8.7 DAMAGE 13
iii