Remote Starter Feature Programming
To Enter Remote Starter Feature Programming:
1. Turn “ON” the ignition key.
2. Toggle the Valet switch “ON” and “OFF” [10] times within 30 seconds after turning “ON” ignition.
3. The LED and parking lights will flash [10] times. The siren/horn chirps [10] times.
4. You are now in remote starter feature programming mode.
Remote Run Time with Gas or Diesel Engine [Default is 14 minutes and Gas Engine]
The module can be programmed for a 14 or 21 minute run time. In addition, the delay before cranking is
programmable for a gas or diesel engine. Gasoline engine setting is [5] second delay before cranking.
Diesel engine is [18] second delay.
For 14 Minute Runtime with a Gasoline Engine: [Factory Default Setting]
• Depress the “LOCK” button.
• The LED and parking lights will flash [1] time. The siren/horn will chirp [1] time.
For 21 Minute Runtime with a Gasoline Engine:
• Depress the “LOCK” button.
• The LED and parking lights will flash [2] times. The siren/horn will chirp [2] times.
For 14 Minute Runtime with a Diesel Engine:
• Depress the “LOCK” button.
• The LED and parking lights will flash [3] times. The siren/horn will chirp [3] times.
For 21 Minute Runtime with a Diesel Engine:
• Depress the “LOCK” button.
• The LED and parking lights will flash [4] times. The siren/horn will chirp [4] times.
Starter Release Circuitry [The Factory Default Setting is Voltage Mode]
You can program the Remote Starter for voltage, tachometer signal or fixed cranking time mode. For
voltage mode there are no extra hook-ups or additional programming required.
For Tachometer Mode:
For Tach mode, you must program our module to look for a tach signal. In addition, you must connect
our blue/white tach wire to the vehicle tach wire.
To Select the Tach Mode:
• Depress the “UNLOCK” button.
• The LED and parking lights will flash [2] times. The siren/horn will chirp [2] times.
• Start the engine with the ignition key and wait for the RPM's to slow down.
• Depress and hold in the program switch to learn the [RPM] tach signal.
• [The Parking lights will be “ON” steady while learning the RPM's]
• Once the module learns the RPM's, the LED and parking lights will flash [10] times. The siren/horn
will chirp [10] times.
• Release the program switch and turn “OFF” the ignition key to exit tach learning.
To Select Fixed Starter Cranking Mode:
• Depress the “UNLOCK” button.
• The LED and parking lights will flash [3] times. The siren/horn will chirp [3] times.
To Program the Remote Starter Back to Voltage Mode: [Factory Default Setting]
• Depress the “UNLOCK” button.
• The LED and parking lights will flash [1] time. The siren/horn will chirp [1] time.
9
START2 UM 3/5/02 2:31 PM Page 9
