3
Valet Mode and Emergency Disarm Procedure
Remote Security and Keyless Entry Operation (Continued)
To Disarm the Alarm and Unlock the Doors:
• Depress the “UNLOCK” button on the transmitter once.
• The interior lights will turn “ON”, siren/horn will chirp twice, parking lights will flash twice, the doors
will “UNLOCK” and LED will stop flashing.
The interior lights will turn “ON” for 30 seconds or until the ignition key is turned “ON”. If you have the
drivers door “UNLOCK” first option, depress the “UNLOCK” button two times to “UNLOCK” the other
doors. The interior light activation and/or arming/disarming chirps can be programmed off permanently,
if desired.
User Discretion Silent Arming and Disarming:
This feature allows you to retain the normal arm/disarm chirps and allows you to arm/disarm silently.
• To arm or disarm without chirps, depress both the “LOCK” and “UNLOCK” buttons at the same time.
Remote Trunk/Rear Hatch Release:
• Depress and hold the “UNLOCK” button for 3 seconds.
• The alarm will disarm and the trunk/rear hatch will open.
Note: This is a separate extra cost option and the vehicle must have an electric trunk release to have this
feature.
Remote Personal Panic Feature:
When panic is activated, the parking lights flash and the siren/horn sounds.
To Activate: Depress the “PANIC” or “LOCK” button for [3] seconds or more.
To Deactivate: Depress the “PANIC” button again or depress the “UNLOCK” button.
Note: The siren/horn will sound and the lights will flash for [1] minute and reset, if you do not turn “OFF”
panic.
To Lock The Vehicle Without Arming Our Security System:
• Simply “LOCK” the doors using the factory power door lock switch as you exit.
• To use our remote to “UNLOCK” the doors later, depress the “UNLOCK” button.
To Turn the Security Features Off [Valet Mode] or to Disarm the Alarm Without Using the Remote
Transmitter [Emergency Disarm]:
• Turn “ON” the ignition key.
• The system begins looking for Valet switch input data for 30 seconds.
• Switch the valet switch to the “ON” position until the LED illuminates. [2 seconds]
• Once the LED illuminates it indicates that the alarm is now in valet mode.
• Switch the valet switch to the “OFF” position.
• Turn “OFF” the ignition key. The LED begins flashing once every 5 seconds.
• When the ignition key is “ON”, the LED will be on steady to remind you that the alarm is in valet mode.
• While in valet mode the remote starter and remote keyless entry features will operate normally
including the “LOCK/UNLOCK” parking light flash confirmation. However, there is no security
protection and no brake pedal depressed door locking or ignition controlled unlocking.
• The emergency disarm procedure is the same procedure as the valet mode. However, please note that
the alarm will begin sounding [if armed] immediately when you open the door. Enter the vehicle [with
alarm sounding], turn on the ignition, depress and hold the program switch in until the alarm stops
sounding [for approximately 2 seconds]. The alarm will remain in valet mode until you turn the security
features back “ON”.
START2 UM 3/5/02 2:31 PM Page 3
