6
Feature Programming
To simplify the procedures we have divided the feature programming into four groups. Please review the
factory settings and decide if you require any changes. No programming can be performed while the
module is in valet mode.
Basic Overview on How to Perform Feature Programming:
• Turn “ON” the ignition key.
• Toggle the Valet switch the appropriate number of times for the group of features you want to change.
[6, 8, 10, or 15 times]
• Depress the “LOCK” and/or “UNLOCK” button to change the feature.
• Turn “OFF” the ignition key.
• The factory default settings is always [1] LED flash, [1] Parking light flash and [1] siren/horn chirp.
• Therefore, when you first depress the “LOCK” or “UNLOCK” button on the transmitter, it advances the
module to the next feature setting.
• In this case, the module would advance to [2] LED flashes, [2] parking light flashes and [2] siren/horn
chirps etc.
• Simply keep re-depressing the transmitter button again until the module advances to your desired
setting.
Transmitter Code Learning
To Enter Code Learning Mode: [The Module Learns Up To 4 Transmitter Codes]
1. Turn “ON” the ignition key.
2. Toggle the Valet switch “ON” and “OFF” 3 times within 30 seconds of turning on the ignition key.
3. The LED will be on solid and the siren/horn will emit [1] long chirp to indicate you are now in code
learning mode.
4. Depress the “LOCK” button on the first transmitter.
5. The LED will begin flashing slowly and the siren/horn will emit [1] short chirp.
6. Depress the “LOCK” button on the second transmitter.
7. The LED will flash slowly and the siren/horn will emit [1] short chirp.
8. Repeat the above steps [4] and [5] for the third and fourth transmitter if applicable.
9. Turn “OFF” the ignition key. The horn will emit [1] short and [1] long chirp to indicate you are out of
code learning.
Note: If a fifth transmitter is programmed in, it erases the first transmitter etc.
To Erase the Codes of A Lost or Stolen Transmitter:
1. Enter transmitter code learning as usual.
2. Depress the “LOCK” button on your [1] remaining transmitter [4] times.
3. Alternatively you can purchase an additional transmitter and program in the [2] transmitters twice each etc.
4. The idea is to fill the memory bank with [4] codes to delete the old codes.
START2 UM 3/5/02 2:31 PM Page 6
