Carbine PLUS-4500, Руководство пользователя и инструкция по установке

Страница: 18 / 20

18
Power Requirements . . . . . . . . . . . . . . . . . . . . . . . . 12.5 Volts Negative Ground
Trigger Inputs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Grounded Pin Switch, Positive Pin Switch,
Electronic Sensor Ground, 0.6 Volt Current Drop
Current Requirements . . . . . . . . . . . . . . . . . . . . . . . Less Than 15mA Armed or Disarmed
Timers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Programmable Automatic Arming Timer
Programmable Re-Arming Timer
60 Second RF Tamper Re-Arming Timer
5 Second Zone By-Pass Re-Activation Timer
Grounded Output Wire Capacity (White Wire) . . 500mA
Siren Output Wire Capacity . . . . . . . . . . . . . . . . . . 2 amps
Channel 2 Pulsed Output. . . . . . . . . . . . . . . . . . . . 300mA
By-Pass Zones . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Zones
Transmitter Frequency . . . . . . . . . . . . . . . . . . . . . . 434mHz
Digital Code Combinations . . . . . . . . . . . . . . . . . . 68,000,000,000
Code Method . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Digital Code Hopping
Transmitter Buttons . . . . . . . . . . . . . . . . . . . . . . . No More Than 4
Receiver Channels . . . . . . . . . . . . . . . . . . . . . . . . . No More Than 3
Ignition Controlled Door Locking:
(Door lock activation must be installed)
When programmed on in “Remote Feature Programming”, ignition controlled locking is active 3 seconds
after the ignition key is set the on position, the door locks will automatically become locked. When the
ignition key is turned to the off position, the door locks will unlock.
Note: If a protected entrance (Door) is open when the ignition key is set to the on position, the door locks
will not lock. This is a non-deletable protective measure.
Channel #2 Output:
(If Installed)
Press and hold the aux (
*
) button for 3 seconds. The designated channel 2 output wire from the alarm
will become grounded for as long as aux ( * ) is pressed.
Dual Zone Sensor Pre-Warning Indicator:
(If Installed)
1. Close all protected entrances and place the alarm in an armed condition.
2. Rap the vehicles body panels to activate the pre-warning zone of any dual zone type sensor.
3. When the pre-warning indicator is triggered, the horn/siren will beep 1 time.
Step 9: Speciality Feature and Optional Equipment Testing
Specifications