Carbine PLUS-4500, Руководство пользователя и инструкция по установке

Страница: 16 / 20

16
Override Operation:
(Security System is Armed)
1. Enter the vehicle and the security systems will begin sounding at this point. Make sure that the
valet/override switch is in the “off” position
2. Place the ignition key into the ignition switch and turn the ignition switch to the “on” position.
3. Within 5 seconds of turning the ignition key “on”, place the valet switch to the “on” position.
4. The horn/siren will stop sounding.
5. The LED indicator will be solid red.
The security system is overridden and is now in the valet mode!
Note 1: If the valet switch is already in the “on” position when you turn “on” the ignition key, the override
function will be bypassed. Turn “off” the ignition key, place the valet switch in the “off” position and try again.
Note 2: If you fail to place the valet switch to the “on” position within 5 seconds of turning “on” the
ignition key, the override function will be locked out. Place the valet switch in the “off” position, turn “off”
the ignition key and try again.
Valet Operation:
(The security system is already disarmed)
1. Make sure that the valet switch is in the “off” position.
2. Turn the ignition key to the “on” position
3. Within 5 seconds of turning the ignition key, place the valet switch to the “on” position.
4. The LED will be on solid indicating that the security system is in the valet mode.
Note: If the unit is in valet mode the LED will be on solid when the ignition key is on only. When the
ignition key is off the LED will flash once every 5 seconds.
How to Get Back to Security System Activation Mode:
1. Place the ignition key switch to the “on” position.
2. Place the valet switch to the “off” position.
3. Place the ignition key switch back to the “off” position. You will notice that the LED indicator will be
off. This indicates that you have exited the valet mode and your security system will operate normally.
Starter Disable:
(If Installed) (Also Applies to Fuel Management Disable if Installed)
1. Enter the vehicle and close all the entrances.
2. Press the lock button on the transmitter.
3. Turn the ignition key to the start position. The engine will not crank over.
4. Turn the ignition key to the off position and press the unlock button on the transmitter.
5. Turn the ignition key back to the start position and the engine will crank over and start.
Step 9: Speciality Feature and Optional Equipment Testing