docs.carbide3d.com
34
Install the X-Rail Belt
1.
Attach a belt clip to one end of a belt. (Refer back
to
Figure 5-4
.)
2.
Set the belt clip on top of the X-rail next to the
Y1-carriage. The belt should lay flat, teeth down,
and extend along the X-rail towards the Z-Plus.
Ensure the teeth of the bottom 2-inches of belt
interlock with the top. See
Figure 5-5
.
3.
Use the 4mm hex key and one (1) M5x10mm
socket head cap screw to attach the belt clip to
the Y1-carriage. Insert the screw from the
OUTSIDE and tighten. See
Figure 5-5
.
4.
Feed the belt under the two idlers on the back of
the Z-Plus. Make sure the belt does not twist and
the teeth remain facing down all the way to the
Y2-carriage. See
Figure 5-6
.
Do not attach the other end of the belt just yet.
5.
Slide the 3mm hex key under the belt, between
the two idlers. Use the hex key as a lever against
the X-rail to push a loop of belt up between the
two idlers as shown in
Figure 5-7
.
Figure 5-5
Figure 5-6
Figure 5-7
Содержание SHAPEOKO XXL
