Carbide3D SHAPEOKO XXL, Инструкция по сборке

Страница: 25 / 71

support@carbide3d.com
23
Attaching Router Mount to Tramming Plate
1. Align the router mount to the FRONT of the tramming plate with the Carbide 3D logo facing UP.
2. Line up the two (2) central through-holes of the tramming plate with the two (2) screw holes at the BACK of
the router mount.
3. Add one drop of Loctite 242 Threadlocker to the threads of the two (2) pocketed screw holes at the back of
the router mount AND the threads of the two (2) M5x16mm button head cap screws. See
Figure 3-11 .
4. Use the 3mm hex key and the two (2) M5x16mm button head cap screws to secure the router mount to the
FRONT of the tramming plate and fully tighten. See
Figure 3-11 .
Attaching Tramming Plate to Z-Plus
1. Place the Z-Plus face UP, resting on the X-motor,
Z-motor pointing away from you.
2. Position the router mount with “Carbide 3D” logo
upright and tramming plate resembling the letter
“U.” Place it onto the front of the Z-Plus and align
the four (4) tramming plate through-holes with
the four (4) available M5 screw holes on the front
of the Z-Plus.
3. Use the 4mm hex key and the four (4) M5x8mm
socket head cap screws to secure the router
mount and tramming plate to the Z-Plus and
tighten.
Figure 3-12 .
Figure 3-11
PRO TIP: This step requires use of Loctite 242 Threadlocker. You may find it helpful to dry fit the router
mount to the tramming plate before adding Threadlocker to ensure proper orientation before final assembly.
Figure 3-12