Carbatec TJ-X300C, Руководство пользователя

Страница: 15 / 45

E) as far as it will go, or remove it from the machine entirely.
4. otate the cutterhead to avoid knife interference.
5. Place a straight edge (D) across the front of the outfeed table (F) and extending
over the infeed table (G). Note the position of the infeed table (G). Note the position
of the straight edge in Figure 6 with respect to the fence (H).
6. aise the infeed table (G) until it contacts the straight edge (D).
he straight edge should lie level across both tables. Move the straight edge to the
back of the outfeed table as shown in Figure 7 and perform the same test.
If the straight edge does not lie level, the front or back of one of the tables must be
adjusted to make the tables coplanar. Proceed as described in
Performing the Coplanar Alignment
If alignment is required as determined in the previous section, proceed as follows:
Disconnect machine from power source before making any adjustments. Failure to
comply may cause serious injury.
1. Disconnect power from machine.
2. nlock both cabinet lock handles (A2).
3. aise the table (D) fully upright.
Adjustment is performed by means of four
setscrews (B2) that adjusts the table pitch
and tilt at the back (towards the fence) and
two hex cap screws (A1) that adjusts the
table toward the front.
Adjustment can consist of a front
adjustment, rear adjustment or (more
probable) a combination of both.
Rear adjustment
ools required – 13mm wrench, 4mm hex
wrench
1. ith a 13mm wrench, loosen three hex
cap screws (B1).
2. sing a 4mm hex wrench, make very
slight adjustments of 1/8 to 1/4 turns to
four setscrews (B2) as required. A
clockwise turn will raise the table; a
counterclockwise turn will lower the table.
Adjusting the two right setscrews will have
greatest adjustment impact to the table's
right side; adjusting the two left setscrews
will have greatest adjustment impact to the
table's left side.
3. hen adjustment is complete, tighten
the hex cap screws (B1)
Front adjustment
ools required – two 13mm wrenches