Carbatec TJ-X300C, Руководство пользователя

Страница: 13 / 45

Note:
A depth of cut of 1.5mm or less is recommended.
Cutterhead Guard
Properly positioned, the cutterhead guard (H) should rest against the fence (A).
Fence Movement
eferring to Figure 7:
he fence (A) can be moved forward (B) or
backward (C) across the width ( ) of the table. It
also tilts up to 45 degrees backwards
(D).
Loosen the lock knob (J), slide the
guard into
position, then tighten the lock knob.
o slide fence forward or backward:
hen edge jointing, the fence
assembly should
periodically be moved to different
positions to
distribute wear on the cutterhead
knives. his is
done as follows:
1. If necessary, loosen the cutterhead
guard (H)
to permit the fence assembly to move
freely
without being constrained by the
guard.
2. Loosen two fence assembly locking handles (E).
3. Move the entire fence assembly to the desired position; then re-tighten the
handles (E).
4. eadjust and secure the cutterhead guard. o tilt fence backward:
he fence (A) can be tilted backward (D) up to 45°(that is, for a total included
angle of 135° from table surface) as follows:
1. Loosen locking handles (F).
2. ilt the fence back (A, C) to the desired angle up to 135 degrees. Or you can
place your beveled reference piece on the table and against the fence, adjusting the
fence until the angle of the fence matches the bevel of your gauge piece.
3. ighten the locking handles (F).
4. eadjust and secure the cutterhead guard.
Adjustments
Table and Knife Adjustments
For accurate jointing, at least three things must be
true: