Carbatec TJ-X300C, Руководство пользователя

Страница: 14 / 45

1. Infeed and outfeed tables
must be coplanar.
2. Knives or knife inserts must
be set in the cutterhead so that
the highest point of their arc is
level with the outfeed table.
3. On the standard cutterhead,
knives must be parallel with the
outfeed table across the entire
length of the knives.
hese alignments are explained
below.
Disconnect machine from power
source before making any adjustments. Failure to comply may cause serious injury.
Coplanar Alignment
Definition of coplanar
hen the infeed table is set to the same level as the outfeed table and together
both tables form a "perfect" flat surface, the tables are said to be coplanar.
For optimum performance of the jointer, the infeed and outfeed tables must be
coplanar. If they are not, the finished workpiece may have a slight taper or twist
across jointed its width or length.
Determining if tables are coplanar
he tables have been set coplanar at the factory, but they should be
double-checked by the operator.
Also, as the machine undergoes use,
the
tables should be checked
occasionally and adjusted if
necessary.
he procedure described below
uses a steel straight edge to set the
tables, which should be accurate
enough for most purposes.
Important:
he tables must be
locked in position when performing
the following test.
eferring to Figures 8 and 9:
1. Disconnect jointer from power
source.
2. Loosen the lock knob (A) and
slide the cutterhead guard (B, C) to
clear the table.
3. lide the fence assembly back (H,