Capital MAESTRO SERIES, Инструкция по использованию и уходу

Страница: 9 / 36

8
DRAWER AVAILABLE FOR
30 LBS HORIZONTAL LP TANK
Grills that have orifices for use with LP gas come equipped with capacity hose/regulator assembly for con-
nection to a standard 30lb. cylinder (Type 1). The LP tank is not included.
Connection:1/2” NPT MALE WITH A 3/8” Flare adapter (included). LP hose with a quick disconnect and fit-
tings
are included. Operating Pressure: 10.0” W.C.
To connect the LP regulator/hose assembly to the tank/valve assembly, first make sure the main valve on
the tank is completely closed. Although the flow of gas is stopped when the Type 1 system is disconnected
as part of its safety feature you should always turn off the LP tank main valve (Fig 2) after each use and dur-
ing transport of the tank or unit. Insert the regulator inlet into the tank valve and turn the black coupler clock-
wise until the coupler tightens up. Do not over –tighten the coupler. Turn the main tank valve ”ON” and turn
the burner control valve on the unit to the “HI” position for about 20 seconds to allow the air in the system to
purge before attempting to light the burners.
LP TANK REQUIRMENTS:
A dented, damaged or rusty LP tank may be hazardous and should be checked by your LP supplier. Never
use a cylinder with a damaged valve. Always check for leaks after every LP tank change. The LP gas cylin-
der must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S.
Department of Transportation (DOT) and designed for use with a Type 1 system only. Do not change the
regulator/hose assembly with a standard 510 POL tank/valve assembly. The cylinder must be provided with
a shut off valve terminating in an LP gas supply cylinder valve outlet specified, as applicable for connection
Type 1. If the appliance is stored indoors, the cylinder must be disconnected and removed from the appli-
ance. Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.
NOTE: When an LP unit is directly connected to in-house LP
system, a step down regulator MUST be used to reduce the supply pressure to a
max. 14”W.C. and min. 11” W.C. to the grill regulator.
LP GAS REQUIREMENTS