Capital MAESTRO SERIES, Инструкция по использованию и уходу

Страница: 21 / 36

20
USING THE ROTISSERIE
Lighting the Rotisserie Burner:
NOTE: The safety valve on all Maestro / Precision Series™ rotisserie sections is in-
cluded in the main burner valve. No separate safety button is necessary to operate the
rotisserie safety feature.
NEVER USE ROTISSERIE BURNER WHEN GRILLING SURFACE IS USED.
The location of the rotisserie burner makes it more
susceptible to strong wind conditions than the
protected grill burners. For this reason you should
avoid operating the rotisserie during windy conditions.
As an added safety feature we’ve equipped the burner
with an automatic safety valve that will not allow gas to
flow to the rotisserie burner unless the following
conditions are present with the knob on.

The safety valve button is pressed and held down.

The safety valve thermocouple has been suffi-
ciently heated to keep safety valve open.
Open the lid. Push and turn the control valve to “HI”
and wait 5 seconds. The igniter will glow brightly to
ignite the burner. Hold the knob pressed in until the
rotisserie burner lights. Once lit keep knob pushed in
and held in position for 10 seconds. DO NOT let go
of the control knob once burner is lit. The burner will
not stay lit unless it is hot. After 10 seconds, release
the knob and set the knob to the desired setting. If
the burner does not light within 4 to 5 seconds,
release the safety valve button and turn the control
knob “OFF” and wait 5 minutes before trying again.

If relighting a hot burner, wait 5 minutes.

Never leave the control knob ON if rotisserie is
not in use.

Never light the bottom burners while the rotisse-
rie burner is lit.
Manual Lighting:
To manually light the rotisserie, place a lighter
flame near the tip of the thermocouple as shown
in Fig. 13 Turn the control knob to “HI”. Hold the
safety valve button in for 10 seconds or until the
burner remains lit. Once lit, turn control knob to
desired setting. If the burner does not light within
4 to 5 seconds, release the safety valve button
and turn the control knob to “OFF” and wait 5
minutes before trying again.