
8
Adjustment of seat depth
Adjustment of seat height
The depth of the seat pan can be adjusted to the front and to the
back within a range of approximately 75 mm. It is possible to set
the seat pan positioning to match your body type while seated by
operating a lever under the seat pan.
By moving levers back and forth that are at both ends of the
bottom section of the front of the seat pan (When the levers are
pushed forward, the seat depth is increased. In addition, the depth
is decreased by pulling them forward.), the depth can be adjusted
by bending the front edge of the seat pan.
Although wrinkling, etc. will occur due to the upholstery (coated
fabric) of the seat pan flexing inward at the time the depth is
adjusted, it can be used without problems in terms of functions.
When adjusting the depth of the seat pan, do not put the weight of
your body on the front edge of the seat pan. This will act as a drag
on the depth adjustment.
When adjusting the depth of the seat pan, be sure to do the adjust-
ment by holding the levers on both ends. Adjustment by holding a
lever on one side only will result in damage and poor operation.
Seat pan depth adjustment lever
Move back and forth
Front edge
of seat pan
When increasing seat height
Be sure to be seated and then pull up the pneumatic height ad-
justment lever under the right side of the seat. If you lift your body
upward gradually while remaining seated, the seat pan will rise.
Let go of the lever when the seat pan reaches the desired height.
When decreasing seat height
Be sure to be seated in the center of the seat pan, and when you
pull up the pneumatic height adjustment lever under the right side
of the seat, the seat pan will move lower. Let go of the lever when
the seat pan reaches the desired height.
Pull upward