Cansec Webster 64, Руководство по установке

Страница: 9 / 32

Webster 64 Page 9 of 32
Installation Manual February 2024 • Rev. 1.1
4. It is highly recommended to use a separate power supply for locks as they
require a high amount of current for proper operation.
Network Information:
1. The Webster 64 Controller is set to acquire an IP address automatically
(
DHCP). However, it can be optionally set to a static IP address or reset if
necessary. See Appendix section for more information.
Mechanical Information :
1. The Webster 64 has 2 horizontal mounting flanges, which should be used to
attach the product to a stable surface.
2. If required the Webster 64 may be mounted inside of a lockable enclosure
such as the CA-SLBOX or CA-H1000ENCL if access is to be limited to the
external connections.
3. If a Lockable external enclosure is used and a Tamper switch is available as in
the CA-SLBOX or CA-H1000ENCL, the Webster 64 has a Panel Tamper
input connection available. Connecting the Tamper switch,
See figure 14, to
this input will produce an Alarm when opening and closing the enclosure.
This Alarm is sent to the Host computer.
Power Issue Indicator :
The controller continuously monitors the main 12 VDC coming into the controller.
In an error condition the onboard beeper sound will be as follow:

Low DC voltage (9 volts or less): 4 one-second beeps then a 2-second pause

High DC voltage (16 volts or higher): 4 half-second beeps then a 2-second pause.
The beep is continuous until the problem is resolved. Also, a message is sent to the
host software e.g. “DC Power Low 9 Volts or Less” or “DC Power High 16 Volts or
Higher”.