Cansec Webster 64, Руководство по установке

Страница: 24 / 32

Webster 64 Page 24 of 32
Installation Manual February 2024 • Rev. 1.1
3. Wait until the Webster 64 does a complete shutdown, indicated by all Webster 64
LEDs going to the OFF state (except the Power LED), and unplug the power
connector.
4. Insert a FAT32 formatted USB flash drive into an available USB connector on the
Webster 64 controller.
5.
Insert the power connector into the Webster 64 controller. The unit will begin the
power up sequence which takes about 30 to 40 seconds. When complete, the
Webster 64 controller will emit 3 beeps.
6. Remove the USB flash drive from the Webster 64 controller.
7. Insert the flash drive
into a USB port on a
computer. When ready,
launch Windows
Explorer or File
Explorer. Access the
USB drive and edit the
file named
MAPCFG.txt
created
by the Webster 64
controller during boot-
up sequence. If the file
is not present, repeat
from step 1. Otherwise
proceed to step 8.
8. A similar file will be
displayed when opened
in Notepad.
Figure 21