Cansec MAP1, Инструкции по установке

Страница: 23 / 31

MAP1 Page 23 of 31
Installation Manual June 2018 • Rev. 1.6

GND – this is the 12 volt power supply ground.

12VDC IN – Power for MAP1. 12 volt DC battery backed up power supply.
This is the power for the MAP1 and readers attached.
PB1 – SHUTDOWN BUTTON
As the MAP1 contains a mini computer, a proper system shutdown is nesscessary to
prevent data corruption.
DO NOT simply unplug the power connector. To shut
down follow this procedure:
1. Use a paper clip or a small screw driver, press and hold (4 to 8 seconds) the PB1
pushbutton until the PLM STATUS LED on the front of the enclosure begins a
rapid green ON/OFF flash.
2. Release the pushbutton. The system will start a proper shutdown. This will take
15 to 20 seconds.
3. Wait untill all LEDs (except power) are turned off by the system. Then remove
the Power Connector.
4. If the Shutdown does not occur, try the procedure again. If it still does not
respond correctly as described above, a system fault has occurred. It will be
necessary to unplug the Power connector and re-insert it after 10 seconds.
PB2 – IP RESET BUTTON AND STATIC IP ADDRESS CONFIGURATION
Note : The new panel is factory set to acquire an IP address automatically (DHCP). If the IP
address has been changed to static address by an installer but now unknown or
forgotten and needs to be reset, follow the instructions below.
Static IP address is recommended only for Webster mode
.
Leave it to
obtain IP address automatically for other modes
.
Alternatively,
s
ee USB IP Configuration Tool section for configuring IP
Address using a USB flash drive.