Canon Super G3 FAX Board-AS, Руководство по обслуживанию

Страница: 73 / 73

Checking the Operation
Type Setting
1. From the following service mode, check that the type
setting of Fax board is [STANDARD] and press OK.
FAX > TYPE > TYPE
2. Confirm that service mode parameter below is "0".
In the case, parameter is "1", change to "0".
COPIER > OPTION > DSPLY-SW > SDTM-DSP
NOTE:
To change parameter to "0" makes no show below
[Settings/Registration > Preferences > Time/Energy
Settings > Auto Shutdown Time] and auto shut down is not
available.
3. Turn OFF/ON the main power switch to enable this
setting.
Basic Setting
NOTE:
When "System Manager Information Settings" is set, be
sure to follow the direction of user administrator in order
to log in as an administrator.
In this section, make only minimum settings required for FAX
communication.
1. Set the user telephone number.
[Settings/Registration] > [Function Settings] > [Send] >
[Fax Settings] > [Set Line] > [Line 1] > [Register User
Telephone No] > Enter the fax number > [OK]
2. Set Type of telephone line.
[Settings/Registration] > [Function Settings] > [Send] >
[Fax Settings] > [Set Line] > [Line 1] > [Select Line Type]
> Select the line type to connect > [OK]
3. Turn OFF/ON the main power switch after setting the
user telephone numbers and the type of telephone
line.
FAX Communication Test
Perform communication test to check if FAX function works
correctly.
1. Switch the control panel display to Send/Fax
display.
2. Send the test document from this machine to
another machine that can handle the
communication test to check that this machine can
send the data correctly.
3. Send the test document from the target to this
machine to check if the machine can receive the
document properly.
6. Installation
68