Canon Saddle Finisher-AF2, Руководство по обслуживанию

Страница: 53 / 244

Chapter 2
2-27
F-2-96
5) Remove the 2 caster covers [1] at the left side. (Figure shows in the case
of using the saddle finisher)
- 2 screws [2]
F-2-97
6) Measure the height [A] from the floor (where caster is landing) to the up-
per surface of the bottom plate using a scale, and check that the height is
within 86.3 +/- 0.3mm. If the height is not within the range, execute step
7) and later.
F-2-98
7) Loosen the caster's fixing nut [1] with the spanner [2] in the direction of
[A].
F-2-99
8) Rotate the adjusting bolt [1] with the spanner [2]. Adjust the height (that
was measured in step 6)) to be within 86.3 +/- 0.3mm.
- To increase the height: rotate in the direction of [A]
- To lower the height: rotate in the direction of [B]
(Height increment per rotation: approx. 1.75mm)
F-2-100
9) Tighten the fixing nut [1] in the direction of [B].
F-2-101
10) Adjust the other 3 casters as well (by repeating the steps above).
11) Reconnect the finisher with the host machine and check the height.
Install the removed parts such as covers if the height difference is within
+/- 2mm. If not, repeat the steps above to readjust the height.
2.5 Attaching the Labels etc.
2.5.1 Affixing the labels
0022-4777
1) Open the finisher front cover [1].
[1]
[2] [3]
[4]
[4]
[1]
[2]
[1]
[2]
86.3 0.3mm
[A]
CAUTION:
When loosening the caster fixing nut [1] at the front side of the saddle
finisher, be sure to insert the spanner [3] into the opening just below the
saddle bottom plate [2].
[1]
[2]
[A]
[1]
[2]
[3]
[1]
[2]
[A]
[B]
[1]
[B]