Canon PowerShot G3, Список кодов ошибок

Страница: 90 / 310

Chapter 2: Service Error Codes
2-30
Cause Remedy
##223 [ TX ] The line was disconnected during
communication
• Transmit once gain. • The Stop button was pressed during im-
age transmission.
Cause Remedy
##224 [ TX/RX ] Fault occurred in the communication
procedure signal
• Check to make user that the document is
placed correctly.
• If the feeding roller is worn, replace it.
• If any image received in memory recep-
tion remains in the memory, print out the
image and empty the memory. Also, avoid
leaving a document in the document tray
unless the machine is in transmission mode.
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
• Start over the communication.
• Print out a communications analysis list for
analysis.
• The document on the transmitting party is
not correctly fed, forcing polling mode to start
(i.e., DCN was received in response to DIS).
• In a memory full condition, a call arrived
when a document was set (i.e., DCN was
received in response to DIS).
• The procedure signal is faulty.
• A fault occurred in a communication pro-
cedure of G4 layer 4 or lower.
• A fault occurred in the G3 communication
procedure on an ISDN line.