Canon PIXMA MP600R, Руководство по установке

Страница: 65 / 740

62 Troubleshooting
EN
G
L
IS
H
Checking information about the network
z “Checking information about the network” on page 74
• “Checking the IP address or the MAC address of the machine” on page 74
• “Checking the IP address or the MAC address of the computer” on page 74
• “Checking the network setting information” on page 74
•
“Confirming the version of Windows XP” on page 74
Cannot connect to the access point (the access point
is not detected)
Before you proceed to Troubleshooting, make sure of the following:
z The USB cable is securely connected to the correct port.
z The MP Drivers are already installed.
z The machine is turned on. If it is, turn it off and then turn it on again.
z There is no barrier or obstacle between the access point and the machine.
Although wireless communication between rooms or floors is possible, the wireless
communication quality may become poor. The wall must be made of a material that allows radio
waves to pass through.
If the wall material prevents communication, set the machine in the same room as the access
point.
z Printing via USB connection is possible.
z The firewall function of security software may prevent proper setup or communication over a
network.
When setting up the machine to be used over a network, disable the firewall function of your
security software during the setup.
If you are using Windows XP Service Pack 1 or earlier and you have Internet Connection Firewall
enabled, a dialog box asking for your confirmation to disable the firewall function will appear
during setup. Click
Yes to disable the firewall function. When setup is complete, the firewall
function will be re-enabled automatically.
To confirm the version of your Windows XP, see “Confirming the version of Windows XP” on
page 74.
z When using a router, connect the machine and computer to the LAN side (on the same network
segment).
MP600R_SG_ENG.book Page 62 Tuesday, August 15, 2006 2:37 PM