iPF6400S Basic Guide
15
Handl
ing
P
ape
r
Ha
ndl
ing
r
oll
s
Note
• The loading method for a printer with a Spectrophotometer Unit (option) is the same as for a
printer with no Spectrophotometer Unit (option). If it is difficult to perform operations from the
front of the printer, lower the Up-down Unit. (See "Lowering the Up-down Unit of the
Spectrophotometer Unit (option) Manually.")
➔
P.19
1
Press the
Load
button.
2
Press
▲
or
▼
to select
Roll Paper
, and then press the
OK
button.
Note
• If any paper has been advanced that will not be used, a message is shown requesting
you to remove it.
Press
▲
or
▼
to select
Yes
, and then press the
OK
button. Remove the paper and go
to the next step.
3
Open the Roll Feed Unit Cover.
4
Holding the Roll Holder flange (a), load the Roll
Holder shaft into the guide grooves (b) on both
sides of the Roll Holder Slot. At this time, load
the shaft so that the color of the Roll Holder shaft
(c) matches the color of the guide groove.
Caution
• Do not release the flanges until you load the holder fully in the Roll Holder Slot. Rolls
are heavy, and dropping a roll may cause injury.
• Be careful not to pinch your fingers between the guide grooves (b) and the Roll Holder
shaft (c) when loading rolls.
