3-10
COPYRIGHT © CANON ELECTRONICS INC. 2011
CANON P-215 FIRST EDITION
CHAPTER 3 DISASSEMBLY & ASSEMBLY
2. Front Roller (drive)
1) Remove the left cover.
2) Remove the gear
{
1
. Using a tool with the
thin tip, unhook the fitting parts
{
2
(2
places), remove the central shaft support,
unhook the fitting parts
{
3
(2 places), and
remove the shaft support at the end and
the front roller
{
4
.
Figure 3-303
Notes on assembling
Install 2 shaft supports in correct direction,
and push them in until they are fitted
properly. Insert the gear to the end with the
D-shaped hole facing outward. Insert the
gear while rotating it slightly because it is
in the form of helix.
3. Registration Roller (drive)
1) Remove the control PCB.
2) Remove 3 screws
{
1
(self-tapping, FH
M2.5x6) and remove the PCB mounting
plate
{
2
.
Note:
The PCB mounting plate includes a tray
detection lever.
Figure 3-304
3) Using a tool with the thin tip, unhook 2
pairs of the fitting parts of 4 shaft supports
{
1
and remove the lower cover
{
2
. Also
remove the part
{
3
of the lower cover that
holds the upper sensor PCB
{
4
.
Note:
The lower cover includes a document
sensor lever.
Figure 3-305