4-2
COPYRIGHT © CANON ELECTRONICS INC. 2011
CANON P-215 FIRST EDITION
CHAPTER 4 INSTALLATION & MAINTENANCE
3. Installing the Software
Install the following software from the
supplied setup disk that is required in order
to use the scanner.
• CaptureOnTouch
• Scanner driver
• Others
Note:
If "CaptureOnTouch Lite" is used, the
above software does not need to be
installed.
Note:
The software should be installed be-
fore connecting the machine to a
computer.
The following shows an outline of the
installation on Windows.
1) Login using an account with Administrator
privileges.
2) Before installing the software, exit all other
applications.
3) Load the setup disk into the DVD drive of
the computer.
4) The setup menu starts automatically.
5) Click [Typical Installation].
Figure 4-101
Finish the installation by following the
on-screen messages.
4. Connecting to a Computer
1) Close the pickup tray and turn the Auto
Start switch "OFF".
2) Connect the machine and the computer
using the supplied USB cable.
Note:
The USB port should support USB 2.0
or USB 3.0.
Auto Start
Auto Start
OFF
OFF
ON
ON
Figure 4-102
3) Open the pickup tray and verify that the
power is switched ON.
Note:
If the cable is connected to the
USB2.0 port, bus power of 5 V 0.5 A is
supplied and if it is connected to the
USB3.0 port, bus power of 5 V 0.9 A is
supplied.
Note:
Although this scanner supports USB
3.0 bus power, USB data transfer rates
remain at USB 2.0 speeds.
Note:
The scanner cannot be used when it is
connected to a computer via a
bus-powered USB hub. A self-powered
USB hub can be used, but operation is
not guaranteed.