Canon F-1, Руководство по обслуживанию

Страница: 134 / 179

4
4
4-58
4-58
Parts Replacing and Cleaning > Consumable parts for periodical replacement and locations for cleaning (DADF) > Height Adjustment
Parts Replacing and Cleaning > Consumable parts for periodical replacement and locations for cleaning (DADF) > Height Adjustment
5) f there is no resistance, perform the height adjustment.
b. Checking the height of rear height adjustment roll.
1) Prepare the paper (plain) with approx. 10 mm in width and approx. 200 mm in length.
2) Align the edge of prepared paper with the contact point of DADF Glass Retainer and the
Stream Reading Glass.
Paper
Reading Glass
Plate
CAUTION:
• Place the paper in the position where it does not contact with the Platen Roller 1.
• If it is placed in the position where it contacts with the Platen Roller 1, checking
cannot be performed correctly.
F-4-157
3) Close the DADF.
4) Pull out the paper in the direction of the arrow and check that there is resistance.
Paper
5) If there is no resistance, perform the height adjustment.
2. Adjustment procedure
1) Rotate the fixing screw on top of the left hinge to adjust it.
To remove the space on the front: rotate it clockwise (black arrow direction)
To remove the space on the rear or both sides: rotate it counterclockwise (white arrow
direction)
Blanking cover
Fixing screw
2) Check the height again and make sure that the height is appropriate.
F-4-158
F-4-159